Home › Machines
Our Injection Moulding Machines: 80T to 220T
Twelve Windsor and Ferromatik Milacron machines with mould temperature controllers, run by a team with 15+ years in moulding.
- 12injection moulding machines
- 80T–220Tclamping force range
- Windsor & Ferromatikmachine makes
- 15+ yearsteam experience in moulding
Machine list
| Number of machines | 12 |
|---|---|
| Makes | Windsor and Ferromatik Milacron |
| Clamping force range | 80T to 220T |
| Mould temperature control | MTC (mould temperature controller) units |
| Operating team | Dedicated moulding team, 15+ years in injection moulding |
| Tool room support | Partner mould makers for new tools, repairs and maintenance |
| Location | 131 S.V. Co-operative Industrial Estate, IDA Bollaram, Hyderabad 502325 |
For the tie-bar gap, daylight and shot capacity of a specific machine, send us your mould details and we will match it to the right press.
Why a spread of tonnage matters
Running a small part on an oversized machine wastes energy and money; running a large part on an undersized one causes flash and short shots. With machines spread between 80T and 220T, each mould goes on a press sized for it, and a second suitable machine is usually available if the first is busy or down. For a buyer, that means fewer missed deliveries.
A common rule of thumb is 2 to 5 tonnes of clamp per square inch of projected part area. On that basis the range covers most small and medium appliance, electrical and consumer parts.
Mould temperature controllers
Many job shops run moulds on plain cooling water and accept whatever temperature the day gives them. We use MTCs to hold the mould at a set temperature. That is what keeps gloss, colour and dimensions the same from the first shot of a lot to the last, and from one lot to the next.
The team
Machines only perform as well as the people setting them. The moulding team here has worked in injection moulding for more than 15 years: setting processes, troubleshooting defects, changing moulds quickly and keeping tools in condition.
Frequently asked questions
What does an MTC do in injection moulding?
A mould temperature controller circulates water or oil through the mould at a set temperature. A steady mould temperature gives consistent surface finish, shrinkage and dimensions, and reduces defects such as flow marks, warpage and sink.
What does machine tonnage mean?
Tonnage is the clamping force that holds the mould shut against injection pressure. Larger projected area or stiffer material needs more tonnage. Our range is 80 tonnes to 220 tonnes.
Are Windsor and Ferromatik good machines?
Both are long-established names in Indian injection moulding. Windsor and Ferromatik Milacron machines are widely installed across the country, with service and spares readily available, which keeps uptime high.
Send us your part
Share a drawing, a sample or a photo with the material, part weight and yearly quantity. We reply with machine fit and a quotation.